TESA / Brown&Sharpe



The TESA MICRO-HITE 3D coordinate measuring system is an affordable high accuracy measuring instrument designed to fill the operational gap between precision hand-held measuring instruments and high end coordinate measuring machines. To assure its high production standards, this advanced measuring system is produced at the TESA factory in Renens, Switzerland in a dedicated manufacturing cell.

The TESA Micro-Hite 3D Recorder is equipped with a simple display and control panel, that allows the automatic reproduction of any manual movements. Through this innovation, the programming time needed for dimensional inspection is notably shorter. The process consists of storing the sequence of the points to be probed in the memory (the system "remembers" all the movements you make and can repeat them). This is done either in manual mode or with the aid of a joystick. The Micro-Hite 3D Recorder then takes over in full DCC (automatic) mode.

The interactive TESA RefleX software and control panel, that control the Micro-Hite 3D family of CMMs allows operators of all skill levels to perform complex inspection routines quickly and efficiently with little training. The offset triangular bridge design of the CMMs provides a low center of gravity and optimum stiffness-to-mass ratio. Air bearings ensure frictionless motion in all three axis.


About the Manufacturer

Tesa Precision Tools are sold under a variety of brand names, including Brown&Sharpe, TESA, Interapid, Standard, and Etalon.

Products

Coordinate Measurement Machines (CMMs)
Hand Tools

Watch Videos

YouTube

Request Brochures or More Information